Cheap solutions in cotton spinning mill
Blow room: 1- Most of the mills have a fire or spark-catching system installed, and its water level and cotton level sensors got damaged. Each of them normally costs 300 USD. It can be replaced by just 1000 to 2000 Rupees only i.e. in about four to six $ 2- Some wire beaters have a small motor to control cotton waste by moving the trash knife or wing, If the wing moving motor gets damaged and does have not in spare then hold and fix the knife by a bolt, adjust the gauge manually, and run the machine. 3- If a Chinese plucker's beater up-down motor is damaging brackets or wheal bracket too much then check if the up-down motor is moving when the plucker is stopped when feed is not required by the subsequent machine, maybe it has stopped over the sensor which gives pulse to go down after every turn if it is the case then the beater up-down motor will start going down and down because the sensor is continuously on so there should be interlocking in such a way that when the plucker is st...